How to wire a 24V flowmeter?

Project Overview

　　Wiring method for 24V flowmeter

　　The wiring method of 24V flowmeter mainly includes four steps: confirming the wiring port, preparing the power supply, connecting the signal line, and conducting power on testing. Firstly, confirm the wiring ports of the flowmeter, which usually include power input port, signal output port, and ground port. Then, prepare a 24V DC power supply, connect the positive pole of the power supply to the power input port of the flowmeter, and connect the negative pole to the ground port. Next, connect one end of the signal line to the signal output port of the flow meter and the other end to the input port of the control system or equipment. Finally, after connecting the power, observe whether the display screen or output signal of the flowmeter is normal.

　　Wiring steps

　　Confirm wiring ports: Find the corresponding wiring port identification on the back or bottom of the 24V flowmeter, usually including power input port, signal output port, and ground port.

　　Prepare power supply: Confirm that the system or device is using a 24V DC power supply, and connect the positive pole of the power supply to the power input port of the flowmeter and the negative pole to the ground port.

　　Connect signal line: Connect one end of the signal line to the signal output port of the flowmeter and the other end to the input port of the control system or equipment.

　　Power on test: After connecting the power supply, observe whether the display screen or output signal of the flowmeter is normal.

　　matters needing attention

　　When wiring, the following points should be noted:

　　Ensure that the power supply voltage is consistent with the voltage required by the flowmeter.

　　When wiring, avoid connecting from top to bottom to prevent rainwater or dew from seeping into the wiring port.

　　After the wiring is completed, conduct a power on test to ensure that the flowmeter is working properly.