Installation requirements for industrial wastewater flow meters

Project Overview

　　Industrial wastewater flow meter consists of two parts: sensor and converter. It is based on Faraday's law of electromagnetic induction work, used to measure the conductivity greater than 5 μS/cm conductive liquid volume flow, is a kind of measurement of conductive media volume flow of inductive instrumentation. In addition to measuring the volume flow rate of general conductive liquids, it can also be used to measure the volume flow rate of strong corrosive liquids such as strong acids and alkalis, and uniform liquid-solid two-phase suspended liquids such as mud, slurry, pulp.

　　Industrial sewage flowmeter is widely used in petroleum, chemical, metallurgy, textile, paper, environmental protection, food and other industrial sectors and municipal management, water conservancy construction, river dredging and other areas of flow measurement.

　　Product features:

　　Full digital processing, strong anti-interference ability, reliable measurement, high precision, flow measurement range up to 150: 1

　　Ultra-low EMI switching power supply, applicable to a wide range of power supply voltage changes, good anti-EMI performance.

　　The use of 16-bit embedded microprocessor, fast computing speed, high accuracy, programmable frequency low-frequency rectangular wave excitation, improve the stability of flow measurement, low power consumption.

　　SMD devices and surface mount (SMT) technology, high circuit reliability.

　　There are no moving parts in the pipeline, no flow-restricting parts, and almost no additional pressure loss in the measurement.

　　The range can be modified online according to the actual needs of users in the field.

　　Measurement results are independent of flow distribution, fluid pressure, temperature, density, viscosity and other physical parameters.

　　High-definition backlit LCD display, full Chinese menu operation, easy to use, simple operation, easy to learn and understand.

　　Industrial wastewater flow meter installation requirements:

　　In order for you to measure correctly, the following requirements should be noted when choosing the location on the pipeline:

　　(1) The sensor can be installed both in the straight pipeline, but also in the horizontal or inclined pipeline installation, but requires the center of the two electrodes connected in a horizontal state.

　　(2) The medium in the installation position should be full pipe flow, avoid than full pipe and gas attached to the electrode.

　　(3) For liquid-solid two-phase fluids, vertical installation, so that the sensor lining wear and tear evenly, to extend the service life.